A070411
Fig. 23.-2 Running a ping test
In the example above, the PC sends a ping command to an Ethernet board connected
to the net with the address 192.168.2.106. If the connection is correct, the following
window appears after the execution of the ping command:
A070412
Fig. 23.-3 Test result of ping command
Now, it is possible to establish a connection with the Telnet server of the Ethernet
module. As before, use the Run command in the PC Start menu. After that, type the
telnet command specifying the Ethernet board IP address as displayed in the
following figure:
A070413
Fig. 23.-4 Running a Telnet client
The following window appears:
128
REF 542plusREF 542plus
Multifunction Protection and Switchgear Control Unit
Operator's manual
1MRS755869
To Next Page
Loading...
