ep shows the configuration parameters of the ports:
*
topology
*
protocol type
*
MAC address (for port1 and port2)
*
IP address (for port1 and port2)
*
subnet mask (for port1 and port2)
*
gateway IP address (for port1 and port2)
es shows the SNTP client configuration parameters
The disks’ contents display the contents of the Flash disk (C:) and Ram disk (D:).
Three commands are available:
fl allows to see the content of the selected disk (C: or D:)
fp allows to select the current disk and path to look at
fs shows the disk usage statistics for the current disk
You can check the SNTP module state by using the following five commands:
sa shows some information regarding the running SNTP algorithm
sc shows the state of the SNTP client
sk shows information regarding the SNTP clock module
ss shows the state of the SNTP server
st shows the result of the last transaction
sx shows all information reported with the previous commands
You can check the internal interface state with the command:
ih shows internal event handler information
ii shows current application state
ip shows internal SPA poller information
is shows internal interface statistics
You can also view the factory test result file with the command:
tf shows stored factory tests report
The following set of commands can be used to check the state of the Dual Channel
operation modality:
da used to print out all the Dual Channel information
dc shows the current Dual Channel configuration
df shows Ethernet Controller statistics
dn shows the table list of the nodes connected
ds shows statistics about Dual Channel communication
dv shows the Dual Channel module release version
Commands related to Modbus TCP protocol are:
130
REF 542plusREF 542plus
Multifunction Protection and Switchgear Control Unit
Operator's manual
1MRS755869
To Next Page
Loading...
