ABB REG650 - Page 13

Completing the test................................................................ 97
Testing control functions...................................................................98
Synchrocheck, energizing check, and synchronizing
SESRSYN................................................................................... 98
Testing the synchronizing function....................................... 100
Testing the synchrocheck check.......................................... 101
Testing the energizing check................................................104
Testing the voltage selection................................................106
Completing the test.............................................................. 106
Interlocking................................................................................ 106
Apparatus control APC.............................................................. 107
Testing logic functions.................................................................... 107
Tripping logic, common 3-phase output SMPPTRC .................107
Three-phase operating mode............................................... 107
Circuit breaker lockout..........................................................108
Completing the test.............................................................. 108
Testing monitoring functions...........................................................108
Event counter CNTGGIO...........................................................108
Limit counter L4UFCNT.............................................................109
Completing the test.............................................................. 109
Testing metering functions............................................................. 109
Pulse counter PCGGIO............................................................. 109
Testing station communication....................................................... 109
Establishing connection and verifying the IEC 61850
communication.......................................................................... 109
Overview.............................................................................. 109
Setting the station communication....................................... 110
Verifying the station communication.....................................111
Exit test mode.................................................................................111
Section 7 Commissioning and maintenance of the fault
clearing system............................................................ 113
Commissioning and maintenance of the fault clearing system.......113
Commissioning tests................................................................. 113
Periodic maintenance tests....................................................... 113
Visual inspection.................................................................. 114
Maintenance tests................................................................ 114
Section 8 Troubleshooting ...........................................................119
Fault tracing....................................................................................119
Identifying hardware errors........................................................119
Identifying runtime errors...........................................................119
Identifying communication errors...............................................119
Checking the communication link operation.........................120
Table of contents
5
Commissioning manual