ABB REG650 - Default Chapter; Table of Contents

Table of contents
Section 1 Introduction.......................................................................7
This manual........................................................................................ 7
Intended audience.............................................................................. 7
Product documentation.......................................................................8
Product documentation set............................................................8
Document revision history............................................................. 9
Related documents........................................................................9
Symbols and conventions.................................................................10
Symbols.......................................................................................10
Document conventions................................................................ 11
Section 2 Available functions......................................................... 13
Main protection functions..................................................................13
Back-up protection functions............................................................ 14
Control and monitoring functions......................................................15
Station communication..................................................................... 18
Basic IED functions.......................................................................... 19
Section 3 Starting up......................................................................21
Factory and site acceptance testing................................................. 21
Commissioning checklist.................................................................. 21
Checking the power supply.............................................................. 22
Energizing the IED............................................................................22
Checking the IED operation.........................................................22
IED start-up sequence.................................................................22
Setting up communication between PCM600 and the IED...............23
Writing an application configuration to the IED.................................28
Checking CT circuits.........................................................................29
Checking VT circuits.........................................................................29
Using the RTXP test switch.............................................................. 30
Checking binary input and output circuits.........................................31
Binary input circuits..................................................................... 31
Binary output circuits................................................................... 31
Checking optical connections........................................................... 31
Section 4 Establishing connection and verifying the IEC 61850
station communication....................................................33
Setting the station communication....................................................33
Verifying the station communication.................................................33
Table of contents
1
Commissioning manual