ABB REG650 - Page 35

IEC13000060-1-en.vsd
IEC13000060 V1 EN
Figure 6: Select the TCP/IPv4 protocol and open Properties
5. Select Obtain an IP address automatically if the parameter DHCPServer is set
to On in the IED.
IEC13000061-1-en.vsd
IEC13000061 V1 EN
Figure 7: Select: Obtain an IP address automatically
6. Select Use the following IP address and define IP address and Subnet mask if
the front port is used and if the IP address is not set to be obtained automatically
1MRK 502 049-UEN A Section 3
Starting up
27
Commissioning manual