I.L. 40-386.3
(10/94) 4-21
TABLE 4-3. TARGET (FAULT DATA) DISPLAY (SHEET 1 OF 2)
Front Panel RCP
Information Display Display
Fault type Flt Type (FTYP) AG / BG / CG / AB / BC / CA /
ABG / BCG / CAG / ABC or
blank if other
Breaker 1 tripped Breaker 1 (BK1) Yes / No
Breaker 2 tripped Breaker 2 (BK2) Yes / No
Zone1 phase trip Zone1ø (Z1P) Yes / No
Zone1 ground trip Zone1G (Z1G) Yes / No
Zone2 phase trip Zone2ø (Z2P) Yes / No
Zone2 ground trip Zone2G (Z2G) Yes / No
Zone3 phase trip Zone3ø (Z3P) Yes / No
Zone3 ground trip Zone3G (Z3G) Yes / No
Pilot phase trip Pilot ø (PLTP) Yes / No
Pilot ground trip Pilot G (PLTG) Yes / No
High set phase trip Inst. ø (ITP) Yes / No
High set ground trip Inst. G (ITG) Yes / No
Close into fault trip CIF Trip (CIFT) Yes / No
Load-loss trip LL Trip (LLT) Yes / No
Ground backup trip GB Trip (GB) Yes / No
Fault location Imp. Flt (Z) magnitude (Ω) and angle (°)
Fault distance Flt Dist (DMI or DKM) in Miles or Kilometers
Prefault load current PFlt I (PFLC) numerical in Amps
Prefault phase voltage PFlt V (PFLV) numerical in Volts
Prefault load angle PFlt Ang (LP) numerical in degrees
Carrier send Car Send (SEND) Yes / No
(continued)
To Next Page
Loading...
