ABB REM615 - DNP3 device profile document

1MAC254287-MB B Section 3
DNP3 protocol implementation
REM615 ANSI 39
Point List Manual
WRITE
binary
outputs
● Never ○ Always ○ Sometimes ○ Configurable
SELECT/OP
ERATE
○ Never ○ Always ○ Sometimes ● Configurable
DIRECT
OPERATE
○ Never ○ Always ○ Sometimes ● Configurable
DIRECT
OPERATE -
NO ACK
○ Never ○ Always ○ Sometimes ● Configurable
Count > 1
(Count > 1 is
accepted but
ignored)
● Never ○ Always ○ Sometimes ○ Configurable
Pulse on ● Never ○ Always ○ Sometimes ○ Configurable
Pulse off ● Never ○ Always ○ Sometimes ○ Configurable
Latch on ○ Never ● Always ○ Sometimes ○ Configurable
Latch off ○ Never ● Always ○ Sometimes ○ Configurable
Queue ● Never ○ Always ○ Sometimes ○ Configurable
Clear queue ● Never ○ Always ○ Sometimes ○ Configurable
The circuit breaker control model is configurable for either direct or SBO mode in the circuit breaker settings. If the operation mode does not
match the CROB, the returned CROB status is hardware error (4). All other control points may be controlled by either direct or SBO controls.
Reports binary input change events when no specific variation
requested:
Reports time-tagged binary input change events when no specific
variation requested:
○ Never ○ Never
○ Only when time-tagged ○ Binary input change with time
○ Only non-time-tagged ○ Binary input change with relative time
● Configurable to send one or the other ● Configurable
Sends unsolicited responses: Sends static data in unsolicited responses:
○ Never ● Never
● Configurable ○ When device restarts
○ Only certain objects ○ When status flags change
○ Sometimes (attach explanation)
● ENABLE/DISABLE UNSOLICITED
function codes supported
No other options are permitted.
Default counter object/variation: Counters roll over at:
● No counters reported ● No counters reported
○ Configurable ○ Configurable (attach explanation)
○ Default object
Default variation:
○ 16 bits
○ Point-by-point list attached ○ 32 bits
○ Other value: _______
○ Point-by-point list attached
Sends multi-fragment responses:
● Yes
○ No
DNP3 device profile document