2105551MNAD | RMC-100 | 39
Positive Acknowledge of receipt of request
Displayed when the valve control option is installed. Process value (PV) is within the user-
set dead band.
Valve is in full open position.
Valve is in full closed position.
Valve is opening. (Open signal is being sent to the valve actuator.)
Valve is closing. (Close signal is being sent to the valve actuator.)
Valve RMC override conditions met (DP/SP override set point or Low Battery)
Local Lock-out is initiated.
Hold: displayed when HOLD flag is active. HOLD displays when PCCU21 is being calibrated.
Zero Flow Condition: visible only when Flow Rate is displayed.
Alarm Condition: need to view alarm. Compare application limits to current values to
determine where the alarm condition is present
A to D Failure: displayed if A to D Converter Absolute Differential Pressure, Absolute Static
Pressure or temperature readings exceed maximum counts or are less than minimum
Back Flow Condition: visible only when DP variable is displayed
Local terminal protocol or TESORO tank gauge
To Next Page
Loading...
