ABB RTAC-01 - Node Address Selection; Programming

Chapter 3 – Installation
3-12 RTAC-01 User’s manual
Node address
selection
If the RTAC-01 module is mounted onto external I/O
Module Adapter AIMA-01, choose the proper node ID
for the module using the node ID selector (S1).
The settings 0…F correspond to node IDs 16…31. The
default setting is 0 (node ID 16).
Setting the node ID is not required when the module is
mounted into SLOT 1 or SLOT 2 on the drive.
Programming
The RTAC-01 is programmed through drive parameters.
These parameters must be checked and adjusted. For
further information, see the drive Firmware Manual,
Parameter Groups 50 and 98.