ABB | SACE Tmax XT
4 | © 2020 ABB | 1SDH001821A1002 - ECN000135670 Introduction | 1 - Contents
Introduction
1 - Contents
Overview
This manual describes the characteristics of the Ekip Touch Trip units installed on SACE Tmax XT7 CB,
among which:
1. general overview:
2. management operations: putting into service, maintenance, troubleshooting
3. operating conditions
4. consultation of menus for changing parameters and displaying measurements
5. accessories
recipients
This manual refers to two user profiles, as defined by standard IEC 60050:
• skilled person, in the electrical field (IEV 195-04-01): person with relevant education, training, knowledge
and experience to enable him or her to perceive risks and to avoid danger which electricity can create
• instructed person, in the electrical field (IEV 195-04-02): person adequately advised or supervised by
electrically skilled persons to enjable him or her to perceive risks and to avoid danger which electricity
can create
IMPORTANT: operations which can be performed by persons trained on the subject
of electricity are specifically indicated in this manual. All the remaining operations
described in this manual must be performed by skilled persons, in the field of
electricity. ABB declines all liability for damage to persons or property caused by
failure to comply with the instructions in this document.
Specifications and supporting
documents
To ensure that Ekip Touch is installed and configured correctly, please read the information in this manual and
in the technical documentation of the product, available in the website
ABB liBrAry
Document Code Description
Technical catalogue 1SDC210100D0201 CB SACE Tmax XT general catalogue
Wiring diagrams 1SDM000002A1001 CB SACE Tmax XT7 Wiring diagrams
Installation instructions 1SDH002013A1001 CB SACE Tmax XT7 Installation instructions
System Interface 1SDH002031A1002 Communication System Interface SACE Tmax XT CBs
Design notes
The information in this manual was written in Italian and then translated into other languages to conform to
the laws and/or commercial requirements concerning the product.
To Next Page
Loading...
