ABB SACE Tmax XT7 - Menu

ABB | SACE Tmax XT
34 | © 2020 ABB | 1SDH001821A1002 - ECN000135670 Ekip Touch - Interface and menus | 4 - Menu
4 - Menu
Introduction
Press Enter or ESC from the main page to access the different menus of the Trip unit.
The menus are the 4th level pages that can be dislpayed and comprise list of:
• submenus
• settable parameters
• information and measurements
• commands that can be executed
Selection of each menu item enables: access to submenus, consultation of information in detail, configuration
of a parameter, execution of a command.
Elements of each item
The items in each list consist of:
• main name (white color)
• additional description or set value (light blue color)
Figure 21
Protections Menu
The Protections menu can be used to configure the following protections
(1)
:
Name Parameters SW package Page
L List and description in dedicated chapter
Standard
Protections
44
S List and description in dedicated chapter 45
S2 List and description in dedicated chapter 46
I List and description in dedicated chapter 47
G
(2)
List and description in dedicated chapter 48
Gext
(2)
List and description in dedicated chapter
(3)
79
MDGF
(2)
List and description in dedicated chapter
(4)
80
(1)
if the Adaptive Protections package is available and Dual set has been activated, an intermediate menu
where the set can be selected (Set A / Set B) will be available before the list of protections page 70
(2)
available for LSIG versions
(3)
available if the presence of toroid S.G.R. has been activated previously
(4)
available if the presence of the MDGF toroid has been previously activated