ABB SACE Tmax XT7 - Page 37

ABB | SACE Tmax XT
Ekip Touch - Interface and menus | 4 - Menu35 | © 2020 ABB | 1SDH001821A1002 - ECN000135670
Advanced menus
The Advanced menu can be used to configure the following protections
(1)
:
Name Parameters SW package Page
MCR List in dedicated chapter
Standard Protections
49
2I List in dedicated chapter 50
IU List in dedicated chapter 51
UV
(2)
List in dedicated chapter
Voltage protections
53
OV
(2)
List in dedicated chapter 54
UV2
(2)
List in dedicated chapter 54
OV2
(2)
List in dedicated chapter 55
VU
(2)
List in dedicated chapter 55
S(V)
(2)
List in dedicated chapter
Voltage Advanced protections
56
S2(V)
(2)
List in dedicated chapter 57
RV
(2)
List in dedicated chapter 59
UF
(2)
List in dedicated chapter
Frequency protections
60
OF
(2)
List in dedicated chapter 61
UF2
(2)
List in dedicated chapter 61
OF2
(2)
List in dedicated chapter 62
RP
(2)
List in dedicated chapter
Power protections
63
D
(2)
List in dedicated chapter 64
RQ
(2)
List in dedicated chapter 67
OQ
(2)
List in dedicated chapter 66
UP
(2)
List in dedicated chapter 67
OP
(2)
List in dedicated chapter 66
ROCOF
(2)
List in dedicated chapter ROCOF protections 69
R STALL
(2)
List in dedicated chapter
Motor protections
72
R JAM
(2)
List in dedicated chapter 72
UC
(2)
List in dedicated chapter 73
U
(2)
List in dedicated chapter 73
PTC
(2)
List in dedicated chapter 74
Signallings
Threshold 1 I1, Threshold 2 I1,
Threshold Iw1, Threshold Iw2,
Phase Sequence
(2)
, CosØ
(3)
Standard Protections
87
Functions
External Trip, Trip Reset, Switch
On SET B
(4)
87
Synchrocheck List in dedicated chapter
(5)
84
RC List in dedicated chapter
(6)
82
(1)
if the Adaptive Protections package is available and Dual set has been activated, an intermediate menu
where the set can be selected (Set A / Set B) will be available before the list of protections (page 70); The only
menu always present via Advanced is Functions
(2)
available if provided for by Trip unit model or if the relative SW package has been activated, where possible
(page 6)
(3)
CosØ available if provided for by Trip unit model or if the Power Protections package has been activated
(4)
SET B available when Adaptive Protections package is present
(5)
available when Ekip Synchrocheck is present
(6)
available when Rating Plug type Rc is installed in unit and when presence of toroid Rc has been
previously activated in Settings menu