ABB SAM600 Series - Page 10

5.6.2 Set time .........................................................................................................................................37
5.6.3 Simulation mode......................................................................................................................... 38
5.6.4 Reset to factory default ............................................................................................................ 39
5.6.5 Indicate module .......................................................................................................................... 39
Section 6 Communication with PCM600 and SAM600 system ...................................41
6.1 Common write.................................................................................................................................. 41
6.2 Common read .................................................................................................................................. 43
Section 7 Event viewer tool.............................................................................................. 47
Section 8 IED configuration migration tool .................................................................. 49
8.1 Migration Procedure....................................................................................................................... 49
8.1.1 Export and import of project....................................................................................................49
8.1.2 IED configuration migration (ICM).......................................................................................... 50
Section 9 Glossary............................................................................................................. 53
Section 10 SAM600 parameter settings........................................................................... 55
Table of contents
2 SAM600 Process Bus I/O System
Engineering manual
© Copyright 2017 ABB. All rights reserved