ABB SAM600 Series - Reset to Factory Default; Indicate Module

IEC18000672 V1 EN-US
Figure 41: PCM600: SAM600 module Simulation Mode
5.6.4 Reset to factory default
GUID-0C3BB09C-ED84-4A59-96CF-1A94AF747B3B v1
Reset to Factory Default can be launched from a SAM600 system configuration context menu,
see Figure 42. This clears the configuration including sample values and set the parameters,
technical key to its default value. The physical topology is retained as it is.
IEC18000674 V1 EN-US
Figure 42: PCM600: Reset to Factory Default
5.6.5 Indicate module
GUID-E62C6335-5B02-41A7-96CA-4E9498E22079 v1
Indicate Module action can be launched from the module context menu. This tool identifies
the physical hardware module in a SAM600 system. When Indicate Module option is selected,
LEDs on the corresponding hardware module flashes for 20 seconds.
1MRK 511 433-UEN B Section 5
SAM600 Engineering
SAM600 Process Bus I/O System 39
Engineering manual
© Copyright 2017 ABB. All rights reserved