SAM600-specific functionalities like
Indicate Modules
,
Get Serial Number
,
Set Simulation Mode
and
Reset to Factory Default
are available to support the engineering, commissioning and
operational phase of the project.
Once the engineering of a SAM600 system is done, the results are written to a SAM600
system. Conversely, engineering information can be uploaded from a SAM600 system for
various purposes.
The connection between the physical SAM600 system and PCM600 is established via USB link.
1MRK 511 433-UEN B Section 2
Engineering tool set
SAM600 Process Bus I/O System 7
Engineering manual
© Copyright 2017 ABB. All rights reserved
To Next Page
Loading...
