2 CI/SM500F–EN Rev. A
Health & Safety
Safety conventions
Symbols that appear in this document are explained below:
Safety precautions
Be sure to read, understand and follow the instructions
contained within this manual before and during use of the
equipment. Failure to do so could result in bodily harm or
damage to the equipment.
Potential safety hazards
Electrical
Safety standards
This product has been designed to satisfy the requirements of
IEC61010-1:2010 3
rd
edition 'Safety Requirements for Electrical
Equipment for Measurement, Control and Laboratory Use' and
complies with US NEC 500, NIST and OSHA.
EC Directive 89/336/EEC
Electrical – In order to meet the requirements of the EC
Directive 89/336/EEC for EMC regulations, this product must
be used in an industrial environment.
End-of-life disposal
Cleaning
The complete recorder can be hosed down if it has been
installed to IP66 / NEMA 4X standards – see Section 2 on
page 5.
Warm water and a mild detergent can be used.
Symbols
Symbols that appear on this product are shown below:
WARNING – Bodily injury This symbol in conjunction
with the signal word 'WARNING' indicates a potential
electrical hazard. Failure to observe this safety
information will result in death or severe injury.
CAUTION – Minor injuries A caution is used to
indicate a condition which, if not met, could cause minor
or moderate personal injury and / or damage to the
equipment. Do not proceed beyond a caution until all
conditions have been met.
IMPORTANT (NOTE) A note is used to indicate
important information or instructions that should be
considered before operating the equipment.
WARNING – Bodily injury Installation and maintenance
of this product must only be conducted by personnel
authorized to work on electrical installations and in
accordance with relevant local regulations.
WARNING – Bodily injury To ensure safe use when
operating this equipment, the following points must be
observed:
– Up to 240 V AC may be present. Be sure to isolate
the supply before removing the terminal cover.
– Normal safety precautions must be taken to avoid
the possibility of an accident occurring when
operating in conditions of high pressure and / or
temperature.
Safety advice concerning the use of the equipment
described in this manual or any relevant Material Safety
Data Sheets (where applicable) can be obtained from
the Company, together with servicing and spares
information.
The recorder contains a small lithium battery that must
be removed and disposed of responsibly in
accordance with local environmental regulations.
The remainder of the recorder does not contain any
substance that causes undue harm to the environment
and must be disposed of in accordance with the
Directive on Waste Electrical and Electronic Equipment
(WEEE). It must not be disposed of in Municipal Waste
Collection.
Protective earth (ground) terminal.
Both direct and alternating current supply.
This symbol, when noted on a product, indicates a
potential hazard which could cause serious personal
injury and / or death. The user should reference this
instruction manual for operation and / or safety
information.
This symbol, when noted on a product enclosure or
barrier, indicates that a risk of electrical shock and / or
electrocution exists and indicates that only individuals
qualified to work with hazardous voltages should open
the enclosure or remove the barrier.
Recycle separately from general waste under the
WEEE directive.
To Next Page
Loading...
