ABB TPL85-B14 - Page 61

Operation Manual / TPL85-B14/-B15/-B16
Maintenance
5
Cleaning the compressor during
operation
5.4
Page 59
© Copyright 2016 ABB. All rights reserved.
May 2016 HZTL2491_EN Revision B
Wet cleaning using external water-pressure vessel (XC3)
Operating state prerequisites for compressor cleaning with XC3
NOTICE
In order to carry out a successful cleaning procedure which has been
tested and is recommended by ABB Turbo Systems, the following pre-
requisite must be met:
 Engine load 25 to 85 %
 Start the cleaning cycle according to following description
Wet clean-
ing procedure with XC3.
Compressor wet cleaning procedure with XC3
 It is mandatory to fulfil the operating condition prerequisites before
cleaning compressors with XC3.
 Remove the sealing plug (X).
 Fill the vessel with the required volume of clean water (see the
Table
of cleaning parameters
).
5.4.1
Operating the water pres-
sure vessel