Operation Manual / TPL85-B14/-B15/-B16
Cleaning the compressor during
operation
© Copyright 2016 ABB. All rights reserved.
May 2016 HZTL2491_EN Revision B
Wet cleaning using vacuum cleaning device on filter silencer (XC4)
Operating state prerequisites for compressor cleaning with XC4
In order to carry out a successful cleaning procedure which has been
tested and is recommended by ABB Turbo Systems, the following pre-
requisite must be met:
Engine load 25 to 85 %
Start the cleaning cycle according to the following description
Wet
cleaning procedure with XC4.
Procedure for compressor wet cleaning with XC4
Cleaning medium vessel 02
When using the cleaning medium vessel on the filter silencer, refer to
the detailed cleaning instructions on the plate (04) attached to the filter
silencer.
To Next Page
Loading...
