Operation Manual / TPS44-F.. - TPS61-F..
2 Safety / 2.10 Lifting loads
© Copyright 2020 . All rights reserved. HZTL2412_EN Rev.G March 2020
In the case of two or more suspension points, the slinging angle must
not exceed 45°. This avoids excessive loading due to inclined tensile
loading.
u Fasten turbocharger assemblies / components as described in re-
spective handling steps.
u Before attaching slings, allow turbocharger components to cool down
(maximum 80°C).
u Use suitable protection at sharp edges.
u Completely screw in assembly / fitting devices without fail so that
they cannot work loose during use.
u Use assembly / fitting devices only for applications described.
u Make sure removed turbocharger components stand safely and se-
curely.
Page 27 / 113
To Next Page
Loading...
Need help?
General
