ABB TPS48-F Series - 6 Troubleshooting; 6.1 Malfunctions when starting

Operation Manual / TPS44-F.. - TPS61-F..
6 Troubleshooting / 6.1 Malfunctions when starting
© Copyright 2020 . All rights reserved. HZTL2412_EN Rev.G March 2020
6 Troubleshooting
6.1 Malfunctions when starting
Sluggish start-up
Possible causes Elimination
Turbochar-
ger
Turbocharger contaminated Clean it
Damaged bearing Contact an ABB Turbocharging
Service Station
Rubbing rotor
Foreign object in turbocharger
Vibrations
Possible causes Elimination
Turbochar-
ger
Rotor unbalance Contact an ABB Turbocharging
Service Station
Damaged turbine or com-
pressor
Damaged bearing
Rubbing of rotating parts
Normal behaviour, no malfunction
Turbochar-
ger
Minor uniform wear around the periphery of rotor components,
caused by slight local rubbing of adjacent components, is per-
missible. The compressor blades and turbine blades are then
shortened somewhat. Certain tolerances must be observed to
avoid a significant loss of efficiency.
¡ If there is any doubt about the extent of rubbing, then an
ABB Turbocharging Service Station must be contacted.
¡ Have a dimension check carried out by an ABB Turbochar-
ging Service Station.
Page 67 / 113