Operation Manual / TPS44-F.. - TPS61-F..
5 Maintenance / 5.4 Cleaning components mechanically
© Copyright 2020 . All rights reserved. HZTL2412_EN Rev.G March 2020
5.4.3 Compressor-end, non-rotating parts
WARNING
Handling operating materials and supplies
Swallowing or inhaling vapours of operating materials and supplies or
contact with them may be harmful to health.
u Do not breathe in these substances and avoid contact with the skin.
u Ensure proper ventilation.
u Observe the information in the material safety data sheet for the op-
erating materials and supplies.
u Wear personal protective equipment (PPE) according to the material
safety data sheet.
u Comply with local legislation.
Wear safety goggles.
Wear safety gloves to protect against chemical hazards.
Wear a respiratory mask to protect against gases.
The following performance-relevant parts can be cleaned according to
the following description.
72000 Compressor casing
77000 Wall insert
79000 Diffuser
u Clean the components specified above with steam or allow to soak in
diesel oil or water with household detergent. After soaking, remove
the dirt with a brush.
u Dry components completely.
u Spray cleaned surfaces with penetrating oil. Do not spray the outer
surfaces of the turbocharger.
u Dispose of dirty water and cleaning agent in accordance with the spe-
cifications in the safety data sheet.
Page 59 / 113