30 TTF200 FIELD-MOUNT TEMPERATURE TRANSMITTER | OI/TTF200-EN REV. A
9.1 Possible HART error messages
Range Displays
the
device
status
Displays
the DIAG.
NO.
Cause Remedy
Electronics F 1 Device defective Replace the device
Electronics S 2 Ambient temperature overshot /
undershot
Check environment; reposition measuring
point if required
Electronics F 3 EEPROM defective Replace the device
Electronics M 4 Electronics overload Factory reset
Electronics F 5 Memory error Factory reset
Electronics I 7 LCD display connected Status info; not an error
Installation /
Configuration
I 8 Device write-protected Status info; not an error
Electronics I 9 EEPROM busy Status info; not an error
Electronics F 12 Sensor input defective (communication) Replace the device
Electronics F 13 Sensor input defective (error) Replace the device
Electronics F 14 Sensor input defective (ADC error) Replace the device
Installation /
Configuration
C 32 Diagnostics simulation mode Not an error, diagnostic info, measurement
OK
Sensor F 34 Measuring error, sensor Check sensor connection
Sensor F 35 Short-circuit, sensor Check sensor connection
Sensor F 36 Wire break, sensor Check sensor connection
Sensor F 37 Range overshot, sensor Check measuring limits
Sensor F 38 Range undershot, sensor Check measuring limits
Installation /
Configuration
I 41 Single-point adjustment active, sensor Status info; not an error
Installation /
Configuration
I 42 Two-point adjustment active, sensor Status info; not an error
Installation /
Configuration
F 65 Configuration defective Check configuration:
A) Wrong device
B) Span is too small
C) Incorrect configuration data
Installation /
Configuration
C 71 Reconfiguration is running Status info; not an error
Operating conditions F 72 Error in the application Check configuration, connections; reset to
factory settings
Installation /
Configuration
I 74 Analog output adjustment active Status info; not an error
Installation /
Configuration
C 75 Analog output in simulation Status info; not an error
Operating conditions S 76 Values overshot Check parameters:
A) Sensor limits overshot
B) Span is too small
NOTICE
If the remedial measures listed for the error message do not improve the status of the device, please consult ABB Service.
Change from one to tw o columns
To Next Page
Loading...
