ABB VA Master FAM540 Series - Parameterization of the Device; Parameter Overview

VA Master FAM540 METAL CONE VARIABLE AREA FLOWMETER | OI/FAM540-EN REV. E 49
Parameterization of the device
Parameter Overview
Note
This overview of parameters shows all the menus and parameters available on the device. Depending on the version and
configuration of the device, not all of the menus and parameters may be visible in it.
Menu / parameter Value range/Input type Remark
Main Menu 0 ► Prog.Level 1 Standard
Specialist
Service
Locked
Use the ▲ and ▼ buttons to select the user level
and press the ► button to confirm. Prog.Level Standard
Standard Specialist
Back Edit Cancel Ok
▼
▲
Main Menu 1 ► Language 0 German
English
Language German
German English
Back Edit Cancel Ok
▼
▲
Main Menu 2 ► Prog.Output 0 No function
Pulse output
Min/Max alarm _ _; /_
General alarm _ _; /_
Alarms can be configured as normally closed or
normally open contacts.
See also ‘Prog.Output’ Menu on page 54.
Prog.Output No function
No function Pulse output
Back Edit Cancel Ok
▼
▲
Main Menu 3 ► Min. alarm 0 Numerical Only active if an alarm type is selected.
Min. alarm 0,0 %
0,0 % Min 0 %
Max 105 %
Back Edit Next Ok
▼
▲
Main Menu 4 ► Max. alarm 0 Numerical Only active if an alarm type is selected.
Max. alarm 0,0 %
0,0 % Min 0 %
Max 105 %
Back Edit Next Ok
▼
▲
Main Menu 5 ► Pulse factor 0 Numerical Only active if a pulse output is selected.
Enter as pulse per unit.
Pulse factor 1.000 1/l
1.000 1/l Min 0.001
Max 1000.00
Back Edit Next Ok
▼