ABB Zenith ZTG Series - Return to Automatic Mode, Operating by HMI

35
1
2
1
3
Automatic
mode
I-position II-position
ZTG: I - II
—
Fig. 3.5 Manual mode, operating by handle, open transition I - II
—
Fig. 3.6 The operating handle must set back to
standby slot before moving to the automatic mode
—
3.4 Return to Automatic
mode, operating by HMI
When operating the automatic transfer
switch by HMI, turn the slide switch to Au-
tomatic mode (AUTO). Remark! The han-
dle has to be standby slot (not in use) be-
fore turning to automatic mode.
Notice
When the slide switch is moved to the AUTO
position, the ATS will enter auto mode after a
3 second delay.