Abbott Eterna 16000 - Charging Apparel Configurations; Pectoral Apparel Configurations

4. Ensure the elasc edges of the pocket overlap, fully covering the charger.4.
NOTE:
▪ When the generator enters the charging zone, it beeps connuously unl▪
charging begins.
▪ If the charger does not nd the generator within 90 seconds, the charger beeps▪
two mes and then turns o automacally. You can press the power icon
through the mesh pocket to turn on the charger and align the charger over your
generator.
Counterweight conguraons
1. If connected, release the long strap from the charger pocket. The counterweight1.
should remain buckled to the charger pocket.
2. Posion the charger over your generator.2.
3. Place the counterweight over your shoulder so it rests on your back or around your3.
neck so the counterweight rests on your opposite shoulder.
NOTE: You may need to adjust the length of the strap to t properly.
Figure 4. Charger posioned over generator (le); counterweight posioned over
opposite shoulder (right)
Single-strap conguraons
1. Release the counterweight from the charger pocket.1.
2. Wrap the charging apparel around your chest or over your shoulder and fasten the2.
buckle.
NOTE: If needed, use the excess strap near the buckle to ghten or loosen the
apparel.
3. Adjust the strap unl the charger is comfortably posioned over your generator.3.
Figure 5. Single-strap around chest (le); single-strap around one shoulder (right)
10