American Beer Equipment 2001 SW 6
th
St.
Lincoln, NE 68522
24
Figure 13. Lid-Escapement Close-up
If lids are not being picked properly, make sure the lid-chute is centered above the can. Also make sure the lid is
positioned properly above the can- the can needs to be centered between the lid’s “pocket” as shown in Figure 13.
Make sure this area is clean and free of sticky beer. Clean and lube before each run. Precise adjustments can be made by
adjusting the wedge rod in Figure 15.
Figure 14. Proper Can and Lid Alignment
To Next Page
Loading...