American Beer Equipment 2001 SW 6
th
St.
Lincoln, NE 68522
9
Figure 3. Individual Nozzle Tunings
b. Seaming
It is up to the brewery, and employees, to determine what a proper seam is and to maintain the seam on every can.
Without a proper seam a can may leak. Therefore, making sure the can seam falls within the manufacturer’s double
seam specifications is of utmost importance. Follow the procedures below to make sure your can is in spec after
installing a new roller operation die. If your seams were previously in spec, but are now on the outside range, please
refer to the Double Seam Setup Procedures.
Proper maintenance of your rollers will prolong repeatable and accurate seaming. Please refer to the Maintenance
Section for more information.
To Next Page
Loading...