American Beer Equipment 2001 SW 6
th
St.
Lincoln, NE 68522
29
Lid-Skimmer Height
Figure 20 Lid Skimmer Assembly
The lid skimmer needs to sit just above the height of a full can. If foam is present, the front of the skimmer needs to just
sit above the foamy lid.
The end of the skimmer should remain lower than the front of the skimmer. The end translates up and down while the
front of the skimmer pivots. The end should be slightly lower than the height of a seamed can.
Adjustments for the height can be made using the adjustment knobs behind the black UHMW skimmer.
c. Seamer (s)
Seamer height adjustment is done by inserting, or taking out an adapter, machined to the correct difference between
the can sizes (Figure 21).
After the heights are changed, you must ensure, using your specific double seam guide, the cans are in spec. Refer to
Double Seam Setup Procedures for more information.
To Next Page
Loading...