American Beer Equipment 2001 SW 6
th
St.
Lincoln, NE 68522
25
Figure 15. Lid-Escapement Adjustment
d) Lid-Tap
If the cylinder touches the lid during your manual testing, but not during a canning run, make sure your flow
controls are not slowing down the cylinder and thus preventing it from quickly tapping the can. However, if you
open them up too much, you may dent the lid or alter the can’s top edge.
**Caution: Exceeding 60 psi may result in damage to the lid tap cylinder and will not be covered by warranty**
e) Other
a. Exahusting flow controls are used on many cylinders.
a. Increasing flow (turning counterclockwise) will increase the flow exiting from the cylinder port.
b. Decreasing flow (turning clockwise) will decrease the amount of flow exiting the cylinder.
f). Mac Valves Manifold Videos
g). E-Stop
a. If nothing turns on or “works”, please check the E-Stop button has not been depressed. The E-Stop must be
reset by twisting it out of its depressed state many times.
To Next Page
Loading...