Abit IB9 - Power Management Setup

BIOS Setup
IB9 2-15
2.6 Power Management Setup
Phoenix – AwardBIOS CMOS Setup Utility
Power Management Setup
ACPI Suspend Type S3(Suspend To RAM) Item Help
- Resume by USB from S3 Enabled
Power Button Function Instant-Off
CPU THRM-Throttling 50.0%
Wake-Up by PME# of PCI Disabled
Wake-Up by Onboard LAN Disabled
Wake-Up by Alarm Disabled
X
- Date(of month) Alarm 0
X
- Time(hh:mm:ss) Alarm 0 : 0 : 0
POWER On Function Button Only
X - KB Power On Password Enter
X - Hot Key Power On Ctrl-F1
Restore On AC Power Loss Power Off

:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
ACPI Suspend Type
This item selects the type of Suspend mode.
- Resume by USB from S3
When set to [Enabled], this item allows you to use a USB device to wake up a system that is in
the S3 (STR - Suspend To RAM) state. This item can be configured only if the item “ACPI
Suspend Type” is set to [S3(STR)].
Power Button Function
This item selects the method of powering off your system:
[Delay 4 Sec.]: Pushing the power button for more than 4 seconds will power off the system.
This will prevent the system from powering off in case you accidentally hit or pushed the power
button.
[Instant-Off]: Pressing and then releasing the power button at once will immediately power
off the system.
CPU THRM-Throttling
This item controls the CPU speed by cutting down its regular power to a percentage during the
STR (Suspend To RAM) state.
Wake-Up by PME# of PCI
When set to [Enabled], access through the add-on PCI card can remotely wake up the system
that was in Soft-Off condition. The PCI card must support the wake up function.
Wake-Up by Onboard LAN
When set to [Enabled], access through the onboard LAN port can remotely wake up the system
that was in Soft-Off condition.
Wake-Up by Alarm
When set to [Enabled], you can set the date and time you would like the Soft-Off PC to
power-on in the “Date (of Month) Alarm” and “Time (hh:mm:ss) Alarm” items. However,
if the system is being accessed by incoming calls or the network (Resume On Ring/LAN) prior to
the date and time set in these items, the system will give priority to the incoming calls or
network instead.