BIOS Setup 3-13
Master/Slave Drive Ultra DMA (For IS7-G, IS7, IS7-E, and IS7-M only)
This item allows you to set the Ultra DMA in use.
[Auto]: The BIOS will select the best available option after checking your hard drive or CD-ROM.
[Disabled]: The BIOS will not detect these categories. If problem arises in using Ultra DMA devices, try
disabling this item.
OnChip IDE-2 Controller:
The description is same as the OnChip IDE-1 Controller.
OnChip Serial ATA Mode: (For IS7-G and IS7 only)
This item determines the mode for on-chip Serial ATA.
[IDE]: The on-chip Serial ATA served as IDE Mode.
[RAID]: The on-chip Serial ATA served as RAID Mode.
NOTE: The [RAID] option is only available when the item “OnChip Serial ATA” is set as [Enhanced
Mode].
SATA RAID ROM:
This item allows you to use the boot ROM of on-chip Serial ATA RAID to boot-up system.
OnChip Serial ATA:
This item determines the function for on-chip Serial ATA.
[Disabled]: Disable the Serial ATA controller.
[Auto]: Allows the Serial ATA controller to be arranged by BIOS automatically.
[Combined Mode]: Parallel ATA and Serial ATA are combined together. Supports up to 4 IDE drives.
[Enhanced Mode]: Enable both Parallel ATA and Serial ATA. Supports up to 6 IDE drives.
[SATA Only]: The SATA is operating in legacy mode.
User’s Manual
To Next Page
Loading...
