3-16 Chapter 3
SuperIO Device:
Click <Enter> key to enter its submenu:
Onboard FDC Controller:
This option enables or disables the onboard FDC controller.
Onboard Serial Port:
This item determines which I/O addresses the onboard Serial Port controller will access.
[Auto]: The system automatically select an I/O address for the onboard Serial Port.
[3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3]: Allows you to manually select an I/O address for the
onboard Serial Port.
[Disabled]: Disables the onboard Serial Port.
Onboard IR Port: (For IS7-G, IS7, IS7-E, and IS7-M only)
This item determines which I/O addresses the onboard IR Port controller will access.
[Auto]: The system automatically select an I/O address for the onboard IR Port.
[3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3]: Allows you to manually select an I/O address for the
onboard IR Port.
[Disabled]: Disables the onboard IR Port.
UART Mode Select:
This item selects the Infrared (IR) function mode.
RxD, TxD Active:
This item sets the IR transmission/reception polarity.
IR Transmission Delay:
This option enables or disables the IR transmission delay. When set to [Enabled], the transmission will be
slower. This is recommended when transmission problem arise.
IS7 Series
To Next Page
Loading...
Need help?
General
