103
Set: Clicking on this will initiate the process for setting the
limitation (see preview, one after the other: left, right,
upper, lower limitation, iris/aperture + button for saving)
Delete: Delete all limitations.
7.7.4 Starting position
Note: the starting positon must be saved as any preset in advance.
Setting for the starting position of the PTZ Dome after restarting
Set: Set the current position as the starting position.
Delete: Delete the current starting position.
Go to: Retrieve a preset (preset position).
7.7.5 Park action
Function for performing a certain action after a defined amount of time (5–720 seconds)
Enable park action: Enable the function.
Park time: This is the amount of time that must pass after manual PTZ control
before the park action function can be re-enabled (5–720 seconds).
Auto-scan: horizontal scan (360°, continuous). The speed can be set from the
basics menu.
Frame scan: horizontal scan, pausing for 4 seconds every 90°.
Random scan: scan at random.
Patrol: start a configured patrol.
Pattern: start a configured pattern.
Preset: retrieve a preset (preset position).
Panorama scan: diagonal scan (360° horizontal, 0~90° vertical, continuous).
Tilt scan: horizontal scan (0~90°).
To Next Page
Loading...
