Motion detection sensitivity
Here you can select the motion detection sensitivity.
PIR
Motion is detected by the PIR sensor.
PIR and motion detection (low)
Low-sensitivity motion detection via the PIR sensor and detection software.
PIR and motion detection (medium)
Medium-sensitivity motion detection via the PIR sensor and detection
software.
PIR and motion detection (high)
High-sensitivity motion detection via the PIR sensor and detection software.
Detection via PIR and detection software functions as an “OR” operation. If
an event is detected by one of the two detection systems, recording will
start/an alarm is triggered.
Motion screen
Select a camera. Select the corresponding tile from the grid to enable or disable the
detection software for this tile. An enabled tile is marked with “V”.
The configured motion screen refers only to the detection software of the
camera. This does not change the settings for detection by the PIR sensor.
The bottom left tile is permanently disabled and cannot be enabled.
Recording duration/alarm settings
Here you can select the desired recording duration and alarm settings.
Recording duration after detection (60 s)
Alarm after motion detection (OFF)
Alarm after loss of video signal (OFF)
Recording duration after detection (30 s)
Alarm after motion detection (5 s)
Alarm after loss of video signal (5 s)
Recording duration after detection (120 s)
Alarm after motion detection (10 s)
Alarm after loss of video signal (10 s)
To Next Page
Loading...
Need help?
General
