Abus Terxon PSTN - User Manual

Questions and Answers

L
Luis PopeAug 4, 2025
What to do if Abus Terxon PSTN Security System dialer does not dial?
- J
  julia63Aug 4, 2025
  If the Abus Security System dialer isn't dialing, the issue might stem from several causes. First, verify that the telephone number programmed is correct. An incorrect trigger polarity or signal could also be the culprit, so check the trigger jumper, trigger signal and wiring of the telephone connection. Finally, if you're connecting to an extension, a missing dial pause or outgoing line could be the reason. Try entering a dial pause or outgoing line.
M
Mary HahnAug 14, 2025
Why can't the recipient confirm the incoming call from Abus Terxon PSTN Security System?
- D
  Denise YoungAug 14, 2025
  If the recipient is unable to confirm the incoming call from the Abus Security System, it could be due to several reasons. Check the confirmation settings in the programming to ensure they are correct. It's also possible that the recipient is using an incorrect confirmation signal, so inform them of the correct alarm confirmation procedure. If the call is being made to a mobile phone, poor mobile reception could be the issue; try changing your location to improve reception.
N
Nicole JacobsAug 23, 2025
How to fix Abus Security System dialer calling subsequent numbers after confirmation?
- C
  Christopher RiveraAug 23, 2025
  If the Abus Security System dialer continues to call subsequent telephone numbers even after the call has been confirmed by the recipient, the issue is likely due to incorrect confirmation settings. You should check the relevant programming to ensure the settings are correct.