Abus Terxon PSTN - Test Functions; Message Test; Auto Report

59
10.11 Test functions
10.11.1 Message test
1. Enter your programming code (default: 1234). The following
message is shown in the display:
READY
Press - depending on which message you wish to play. This
example shows message A:
SEND A
ON 1-4
Press the key again for the corresponding message (key A in this
example).
After a few seconds, the identification message (phrase 0) and the
alarm message are played for the key that was previously selected.
PHRASE 0
PHRASE A
Data entry can be finished by pressing
after the message has
been played.
10.11.2 Auto report
1. Enter your programming code (default: 1234). The following
message is shown in the display:
READY
Press
- depending on which message you wish to send. This
example shows message A:
SEND A
ON 1-4