45
9. Putting into operation
9.1 Factory settings reset
In order to ensure that all existing settings are deleted, a factory
settings reset is recommended after a new installation. You can
choose between a software or hardware reset.
9.1.1 Software reset
1. Press and hold the key. Connect the power supply to the
device. The following display message is shown.
ERASE ?
Press . The display now shows:
LANG ?
Press
. The display now shows:
PLEASE
RECORD
Enter your programming code (default: 1234). You will see the
following message:
READY
GJ Start the programming of the device.
To Next Page
Loading...
