Display of the current stream's resolution
Display of the current connection status
Direct:
The Peer2Peer Server was able to set up a direct connection between your
end device and the camera.
Relay server*:
The Peer2Peer Server was unable to set up a direct connection. The video
data is saved on the relay server for a short time so that your end device can
get the data from the server. This causes a delay to the stream.
Display of the current assessment of the connection
Display of the current kilobit consumption per second
*Note
If the connection to your camera is always made via the relay server, please check the
following settings:
Check whether UPnP is enabled in your router
Check whether a hardware firewall or a software firewall is stopping a direct
connection
Check whether multiple 'hops' (router) are installed between the end device and
the internet.
To Next Page
Loading...
Need help?
General
