11.4. Sound settings (PPIC35520 only)
Melody track : Track 1–5
Change the melody the intercom plays when the call button
is pressed.
Melody volume: Level 1–3
Change the melody volume here
Melody activated: Enable or disable melody playback at the intercom.
Loudspeaker volume: Level 1–4
You can change the volume of the loudspeaker during two-way
communications here
11.5. Relay settings (PPIC35520 only)
External door bell: Silent / 1 sec / 3 sec / 5 sec
Here, you can select the switching time for the relay switch
connected to the external doorbell. Alternatively, you can
disable it if you wish.
Relay: 1 sec / 3 sec / 5 sec
Here, you can change the switching time for the actuator relay
11.6. Network settings
Wi-Fi: Select your home Wi-Fi network from the list of Wi-Fi networks.
Enter the password for your Wi-Fi network and confirm
with 'OK'.
The camera then sets up a new connection. If you have used
the network cable to connect your camera to your router, unplug
this during the restart. If the camera cannot connect after
approx. 90 seconds, restart the camera as your first course of
action. If the camera still cannot connect, reconnect the camera
with the network cable again and check the settings.
To Next Page
Loading...
Need help?
General
