Display the resolution of the current stream
Display of the current connection status
Directly:
The Peer2Peer server was able to establish a direct connection between your
end device and the camera.
Relay server*:
The Peer2Peer server could not establish a direct connection. The video data
is stored on the relay server for a short time so that your end device can obtain
the data from the server. This causes a delay in the stream.
Display of the current assessment of the connection
This represents the connection between the base station and the router.
Display of the currently consumed kilobits per second
*Note
If the connection to your camera is always made via the relay server, please check the
following settings:
• Check whether UPnP is activated in your router
• Check whether a hardware firewall or a software firewall denies a direct
connection
• Check whether several "hops" (routers) are installed between the terminal and
the Internet.
To Next Page
Loading...
