7. During the delay time
Provided no errors that prevent activation have occurred (zone open), the wireless alarm system starts the configured exit delay time. The system emits an acoustic
message. Depending on whether a partition or the complete system is activated, the message is:
“Partition activated” or
“Alarm system activated”
During this period, you must leave the premises.
A continuous tone sounds during the delay time. This tone is also emitted by the info module (if fitted).
Some zones may be left open during activation and the exit delay time (Final Exit, Entry Route). However, these zones must be closed before the delay time expires
– otherwise, a local alarm is triggered.
When “Final Exit” or “Entry Route” zones are open, a pulse tone is emitted during the exit delay time until all zones are closed.
8. Unsuccessful activation
There are two different situations here:
a) The delay time was not started.
b) The delay time was started.
8.1. Delay time was not started
The system does not start the delay time due to a system error.
If you have attempted to activate the system using:
• Fast activation
• Arming station
• Remote control
• Wireless cylinder
then the following display is shown:
An acoustic warning is also issued.
This is as follows:
“The alarm system cannot be activated”
Enter a valid user code in the system and proceed as shown here.
If you have attempted to activate the system using:
• User code
• Chip key
then the display shows the current error.
Select Omit All, to stop monitoring of the zone(s). The delay time starts when
the error is omitted. An acoustic message is played.
“The alarm system is activated with omitted zones”
To Next Page
Loading...
