20
PROGRAMMING
ALL PORTS
Navigate to the ALL port to set simultaneous
programming for all connected devices.
Programming set in this port mode applies to all
connected devices, but will not be active if you
navigate to other ports. Re-entering the ALL
port will resume its programming.
INDIVIDUAL PORT
Navigate to a numbered port with a connected
device to set individual programming.
Programming will run in the background even
while you navigate to other numbered ports.
PORTS
Pressing the port button will cycle through the controller’s available ports: ALL, 1, 2, 3, and 4. Dot
indicates the current device. No digit is displayed if a device is not plugged into the corresponding port.
To Next Page
Loading...
