Access Virus Rack - Page 159

ACCESS VIRUS RACK 157
Multimode parameters
OUTPUT SELECT Several PARTs can simul-
taneously access the external outputs via
OUTPUT SELECT.In SINGLE MODE, OUT-
PUT SELECT does not appear in the
menu; in this case Output 1 (stereo) is
preset.If the selected output is mono-
phonic, then the Panorama settings and
modulations in the sound program are
inactive.
01111111111111111112
1 B36 101BASS RP
OutSel Out1 L+R≤
61111111111111111154
PART TRANSPOSE Transposes the PART
in semitone steps.
01111111111111111112
1 B36 101BASS RP
PartTransp +0≤
61111111111111111154
PART DETUNE Fine-tunes the PART.
01111111111111111112
1 B36 101BASS RP
PartDetune +10≤
61111111111111111154
PART VOLUME Controls the volume level
of the PART. In addition to PATCH VOL-
UME (in the EDIT menu, see appropriate
section), Channel Volume (Controller #7)
and Expression (Controller #11), PART
VOLUME is the fourth option for deter-
mining the volume level of a PART
within a MULTI program. Please keep in
mind that PART VOLUME is a bipolar
parameter: In the negative half of the
control range (-64 to 0) the signal level is
controlled in the normal fashion - i.e. the
sound fades out as negative numbers
increase; from the center value upwards
 OUT 1 L
The left jack of dual Output 1 (mono)
 OUT 1 L+R
Both jacks of dual Output 1 (stereo)
 OUT 1 R
The right jack of dual Output 1 (mono)
 OUT 2 L
The left jack of dual Output 2 (mono)
 OUT 2 L+R
Both jacks of dual Output 2 (stereo)
 OUT 2 R
The right jack of dual Output 2 (mono)