166 CHAPTER 17
The Vocoder
NOTES ABOUT THE VOCODER
The vocoder can also be controlled by
any part of the multimode. If more than
one part of the multimode contains an
activated vocoder, only the vocoder of
the part with the lowest part number is
active.
As mentioned before, the whole filter
section is exchanged to the vocoder,
parameters, parameters like saturation
or the filter routing are not available
anymore.
If you would like to use the vocoder as
an external effect device, choose one
external input in the VOCODER MODE
parameter page (modulator signal) and
the carrier signal by the INPUT SELECT
page.
The effect section (chorus, delay) and the
output selection can be used in a
vocoder patch.
To Next Page
Loading...
