82 CHAPTER 12
Audio Routing
THE AUDIO OUTPUTS
In MULTI mode, you can choose a mono
or stereo audio output in the OUTPUT
Select menu independently for every
PART.
In contrast to the majority of other
effects, the delay/reverb section is not
available individually for each PART.
Instead, it processes the signals of the
PARTs collectively. You can, however,
control the intensity of the effect indi-
vidually for each PART using the respec-
tive Effect Send parameter.
Consequently, the delay/reverb section
has just one signal output, which cannot
be distributed to the outputs of the indi-
vidual PARTs.
This is why, for example, the delay effect
of a PART that is routed to the pair of
outputs labeled OUT 2 will still be audi-
ble on OUT 1. This can be desirable yet
may also lead to confusion. To encour-
age the former and prevent the latter,
set the Effect Send parameter of the
PART to zero when you’re using individ-
ual outputs.
In MULTI mode, the delay/reverb section
feature its own OUTPUT Select that is
independent of the PARTs.
To Next Page
Loading...
