Controller Programming (basic)
Page 12
Water Schedule
The
Watering Schedule
knob position allows you to modify the days of each watering
program. This includes both timer programs (A, B, C, and D) and sensor programs (S1,
S2, S3…S36).
1. Select a Program by pressing the
+
or
-
Adjust
Value
buttons in the
Select Program
field. Timer
programs are A through D and sensor programs
are S followed by the zone terminal number
where they are installed.
2. Press the
Next
button to move to the
Day
Cycle Type
field. This field allows you to select
the day the selected program will water.
Custom:
choose which days the program waters.
Everyday:
allows the program to water everyday.
Odd Days:
allows the program to water only on odd calendar days.
Even Days:
allows the program to water only on even calendar days.
Every__ Days:
allows you to select how many days between watering from every 3 day
to every 30 days.
3. Press
+
or
-
Adjust Value
buttons to select the day cycle type.
4. To adjust
Custom
day cycle type press
Next
and scroll through the days of the week.
The program will water on days of the week showing a water drop and will not water on
days of the week showing an X. Use the
+
or
-
Adjust Value
buttons to change from a
drop to an X.
5. Follow the same instructions for all desired programs.
NOTE
: Though sensor programs are set to water on a day cycle, they may or may not
water due to soil moisture levels.
Manual Program Start
allows you to run a full program manually. To do this highlight
the
Select Program
field using the
Next
and
Prev
buttons. Then select the program you
wish to run using the
+
or
–
Adjust Value
buttons. To start the program press the
Manual Start
soft key.
Note:
The
Manual Start Program
feature will run all the zones for their full duration as
set up in the program. Any other program that may be running at the time you start will be
suspended and will finish after the manual program finishes. If another program is
scheduled to start while a manual program is running, it will be delayed until the manual
program is finished. Multiple program starts can be initiated. They will run in the order
they were initiated and take precedence over scheduled program starts. A given program
can be stacked for manual watering only once. Manual program watering uses the same
flow control settings as does normal scheduled program watering.
To Next Page
Loading...