ACE095 Page 10 of 17 Rev Date: 12.7.2021
4. Motherboard
Location: The motherboard is generally centrally located within the unit. Standard practice
would be to remove all the components, peripherals, and add-ons from the motherboard before
removal of the motherboard for processing.
Type and number of fastenings: 8 Phillips screws.
Tools required: Screwdriver with PH2 bit.
Procedure: Remove all 8 Phillips screws. Lift the motherboard from its base.
Selective Treatment/Special Handling Per Annex VII, Directive 2012/19/EU: Any printed circuit
boards within the motherboard must be removed separately from the motherboard and shall be
disposed or recovered in compliance with Directive 2008/98/EC.
A lithium battery resides on the motherboard. The battery must be removed separately from
the motherboard and shall be disposed or recovered in compliance with Directive 2008/98/EC.
Refer to section 8 for specific instructions on remove and disposal of LiON batteries.
Handle used batteries carefully. Do not damage the battery in any way; a
damaged battery may release hazardous materials into the environment. Do not
discard a used battery in the garbage or a public landfill. Please comply with the
regulations set up by your local hazardous waste management agency to
dispose of your used battery properly.
To Next Page
Loading...
General