Machine Maintenance Procedures 3-27
Thermal Module Removal 0
Prerequisite:
Mainboard Removal
1. Find Thermal module (B) on Mainboard. Refer to Figure 3-20.
2. Loosen three (3) captive screws (A). Refer to Figure 3-24.
3. Disconnect the thermal module cable from the mainboard connector (B)
(Figure 3-24).
4. Remove thermal module from Mainboard.
Figure 3-24. Thermal Module
Thermal Module Installation 0
Apply approved thermal grease and ensure all heat pads are in position
before replacing
module.
Use caution when applying thermal grease. Thermal grease may cause
damage to the mainboard.
The following thermal grease types are approved for use:
Silmore GP50
Honeywell
Jet Motor 7762
To Next Page
Loading...
