Machine Maintenance Procedures 3-43
3. Starting from the top, remove the clear mylar tape (C) and disconnect the LVDS cable from
the LCD panel connector (D)
(Figure 3-41).
Figure 3-41. LVDS Cable
LVDS Cable Installation 0
1. Put LVDS cable into the LCD panel connector (D) and secure clear mylar tape
(Figure 3-41).
2. Put yellow tape (C) on the LVDS cable to secure it. Refer to Figure 3-40.
3. Put LVDS cable (A) on the rear of the LCD panel. Refer to Figure 3-39.
4. Install LCD panel.
C
D
To Next Page
Loading...
