3-78 Machine Maintenance
Replacing the Memory Modules 0
1. Insert the memory module at a 30° angle into the DMI memory slot (1) and then press it
down (2) until it clicks into place.
The module is keyed so it can only be inserted in one direction. If the module does not fit,
make sure that the notch in the module lines up with the tab in the memory slot.
Figure 3-119. DM1 Slot Module
2. If a second memory module is available, install it in the DM2 slot by repeating step 1.
Figure 3-120. DM2 Slot Module
To Next Page
Loading...
